4164/41256 RAM Modification
More actions
Williams MPUs shipped with 24 × Mostek 4116 DRAM (16,384 × 1-bit), introduced in 1977 — only a few years before Defender.
These chips need three voltages (triple-rail):
- +5 V — TTL input/output buffers
- +12 V — primary power
- −5 V — substrate bias / shield
If −5 V drops while +5 and +12 are still present, the chip overheats and fails quickly.
That triple-rail requirement made the 4116 a weak link on these boards, especially as the linear supplies aged and the rails got noisy.
4164 First Successor
In the early 1980s the direct successor appeared: the 4164 (65,536 × 1-bit).
An internal bias generator supplies the −5 V, so the part runs from a single +5 V rail. Pins that used to carry the extra supplies became another address bit, which is how capacity went up. 4164s generally run cooler and tolerate supply variation better.
41256 Last 16-Pin Successor
By the late 1980s density had increased again. Using the last unused supply pin as another address line gave the 41256 (262,144 × 1-bit).
Pinout Comparison
Here is a comparison in pinout:
Modify the MPU
What we need to do: For the 4164/41256 to work, we need to accomplish a few things.
- Remove the -5v from Pin 1
- Remove the +12v from Pin 8
- Substitute +5v on Pins 1 and 8 (If we left these unconnected/Floating, the address value would randomly change
Original MPU Power Connector Pinout
Step 1 — Cut pins 5(+12 Regulated) and 9(-5v) * Keep one of the cut off pins *
